Loop Function In Auto Punch In/Out Mode - Fostex MR-8CD Owner's Manual

When the loop mode is active (while the auto punch in/out mode is inactive), the LOCATE
A and LOCATE B points are used as the loop start and end points. When the auto punch in/
out mode is active (while the loop mode is inactive), the LOCATE A and LOCATE B points
are used as the punch-in and punch-out points.
When both the auto punch in/out and loop modes are active, the LOCATE A and LOCATE
B points are used as the punch-in and punch-out points, while the loop function starts at
"the LOCATE A point minus the pre-roll time" and ends at "the LOCATE B point plus the
post-roll time", as shown below. The pre-roll time is initially set to four seconds, while the
post-roll time is set to one second.
<Note>: If you set the LOCATE A point to the beginning of a song (ABS ZERO) or set the
LOCATE B point to the recording end point (REC END) of a song, the pre-roll or post-roll
time is ignored.
Using the loop function in the auto punch in/out mode reduces the number of key presses,
allowing you to concentrate on playing.
You can change the pre-roll and post-roll time within the range between 0.1 and 10.0
seconds (in 0.1 second steps) in the menu mode (see page 126).
MR-8HD/CD
Owner's Manual (Advanced playback and locate functions)

Loop function in auto punch in/out mode

LOCATE A point
4 sec.
LOOP START point
LOCATE A point
(Punch in point)
LOOP START point
LOCATE B point
1 sec.
LOOP END point
LOCATE B point
(Punch out point)
LOOP END point
47