Mazda 3 Owner's Manual page 513

Mazda3_8CV6-EA-12H_Edition2 Page513
Wednesday, October 17 2012 3:16 PM
5. Disconnect the bulb from the socket.
6. Install the new bulb in the reverse order
of the removal procedure.
í
Fog lights
1. Make sure the ignition is switched off
and the headlight switch is off.
2. Turn the screw counterclockwise and
remove it and then partially peel back
the mudguard.
Form No.8CV6-EA-12H
Black plate (513,1)
Owner Maintenance
3. Disconnect the electrical connector
from the bulb by pressing the tab on
the connector with your finger and
pulling the connector downward.
4. Turn the socket and bulb assembly to
remove it. Carefully remove the bulb
from its socket in the reflector by
gently pulling it straight back out of the
socket.
5. Install the new bulb in the reverse order
of the removal procedure.
í
Side-turn signal lights
Due to the complexity and difficulty of
the procedure, the LED bulbs must be
replaced by an Authorized Mazda Dealer.
NOTE
LED bulb replacement is not possible because
it is built into the unit. Replace the unit.
í
Some models.
Maintenance and Care
8-51