AT&T MERLIN LEGEND Release 2.0 System Programming And Maintenance Manual page 74

System Programming and Maintenance (SPM)
4. Press any key.
When the installation is finished, the following message appears:
SPM HARD DISK INSTALLATION IS NOW COMPLETE
YOU MUST REBOOT YOUR SYSTEM BEFORE USING SPM
5. Remove the SPM diskette from Drive A and reboot your system.
NOTE:
If the OUT OF ENVIRONMENT SPACE error message appears on the
screen, refer to the shell command in your DOS manual.
The installation procedure automatically does the following:
Checks available space on the hard disk. Installation terminates with
an error message if the space is insufficient.
Checks permissions on the autoexec.bat and config.sys files.
Installation terminates with an error message if either file is write-
protected.
Saves a copy of autoexec.bat as autoexec.old.
Saves a copy of config.sys as config.old.
If autoexec.bat has not already been configured for SPM, does the
following:
— Adds C:\spm to the PATH variable.
— Adds the line SET AMS_PATH=C:.
— Adds the background print command
PRINT /D:PRN /B:4096 /U:3 /M:200 /S:1 > NUL.
If config.sys has not already been configured for SPM, adds the line
DEVICE=C:\ANSI.SYS.
Copies the ansi.sys file from the floppy disk to c:\.
Creates the directory c:\spm.
Copies the following files from the floppy disk into c:\spm:
Installing the SPM Software
4 9