AT&T MERLIN LEGEND Release 2.0 System Programming And Maintenance Manual page 69

System Programming and Maintenance (SPM)
CAUTION:
An unsuccessful or aborted Restore results in a frigid start:
All calls are dropped.
The system configuration is erased.
All system programming is lost, and the system returns to the
factory settings.
If the restore is being done remotely, the connection is
dropped immediately.
If this happens, reconnect to the control unit and do another Restore
immediately.
Restore is aborted under the following conditions:
if fewer boards are listed on the disk than on the control unit
if
any real board is out of sequence with the boards listed on the disk
if
phantom boards are not listed last
if
the operating mode of the system being restored is Hybrid/PBX, but
the control unit processor module has been modified with a hardware
strap in place to operate only in Key mode
A successful Restore is followed by a cold start; however, you do not
automatically exit from SPM.
Step Display
1
SPM Main Menu
Menu: Select Function
Sys Program
Backup
Boards
Print Opts
Monitor
44
Restore
Instructions
If you are restoring from diskette, remove
the SPM diskette from Drive A and insert
Maintenance
Restore
Select Restore by pressing [F7] . The
Pass-Thru
two screens shown in Step 2 appear.
Password
Language