Faint Or Blurred Printing; Grey Background - Mita DP-1400 Instruction Handbook Manual

Faint or blurred printing

Check the control panel.
If the Toner low Clean printer message is displayed and the
new toner kit. See Section 4.1.
Set the print density from the control panel to a higher level than the current setting. See Section 2.14.
Make sure the Paper Type setting is correct.
Check the Draft setting.
See Section 2.12.
Cleaning the drum surface
To clean the drum surface, proceed as follows.
MODE
1. Press the key.
2. Press the + or - key repeatedly until the message display indicates >Others.
3. Press the key.
4. Press the + or - key repeatedly until the message display indicates >Sevice >.
5. Press the key.
6. Press the + and - keys to display >>Drum.
7. Pressing the ENTER key will cause? to be displayed.
8. Press the ENTER key. The drum then starts turning and stops after approx. 3minutes.
The printer then reverts to Ready.

Grey background

Check the control panel.
If the Toner low Clean printer message is displayed and the
new toner kit. See Section 4.1.
Check the print density.
Display the print density menu from the control panel and select a lighter density setting. See Section 2.14.
5.4. Print Quality Problems
indicator is flashing, install a
indicator is flashing, install a
5-5