Table of Contents
Advertisement
If you have installed the optional paper feeder, the cassette in the printer appears on the display as
Cassette 1, and the cassettes in the paper feeder appear as Cassette 2 and Cassette 3.
Also, if the Envelop Feeder or Bulk Feeder is installed then MP tray is not displayed and EF or Bulk
feeder is displayed instead.
The current selection is indicated by a green light on the printer symbol above the key.
On-line/Off-line Setting
By pressing the ON LINE key you can change the printer between the on-line state, in which it prints the data
it receives from the computer, and the off-line state, in which it stores the data for printing later.
1.
Make sure that the message display indicates Ready.
2.
Press the ON LINE key.
If the printer is on-line, it changes to off-line. If the printer is off-line, it changes back to on-line.
The ON LINE indicator lights when the printer is on-line.
Going off-line may or may not halt communication between the printer and computer, depending on details
of the current interface. While off-line, the printer continues to accept any data that arrives until the current
interface buffer is full, at which point it instructs the computer to stop sending data. Data stored while off-
line are printed when the printer is returned to the on-line state.
Canceling Printing
Perform the following procedure when you wish to cancel printing after it has begun.
1.
Check if the message Processing is displayed in the message display.
2.
Press the ON LINE key to take the printer offline.
3.
Perform the necessary procedure on the computer to halt printing.
4.
Press the CANCEL key.
5.
The message Print Cancel? will appear in the message display and the interface to be canceled
will be displayed.
Parallel
Serial
Option (appears only when an optional interface is installed)
6.
Selecting the interface to cancel using the + or – key and then press the ENTER key. Printing from the
interface selected will be stopped.
A few pages may be printed even after the CANCEL key is pressed as remaining data received before the
CANCEL key was pressed is printed.
The message Print Cancel? Current job will also be displayed when the CANCEL key is
pressed for the purpose of stopping the printing of status pages or font lists from the control panel. When
the ENTER key is pressed, the message Cancelling data appears in the message display and
printing stops after the printer finishes printing the current page.
Press the CANCEL key again if you wish to stop the cancellation of printing.
Press the ON LINE key to put the printer back online to continue with other print jobs.
Canceling data from the computer using the CANCEL key will restore temporary settings to their
default values. (The same status resulting from executing the PRESCRIBE 2e RES command.)
It is impossible to cancel printing of just one side when printing in duplex mode using an optional
duplexer (AD-34).
2.2. Operating Procedures
2-7
Advertisement
Table of Contents
