Table of Contents
Advertisement
3.
key after selecting the paper type you want to customize. Pressing the + and – keys will
Press the
cycle through a display of the submenus given in the table below.
Submenus displayed
>>Paper weight
>>Duplex path
(only when the paper type
is Custom #)
Display the submenu to be set and press the ENTER key. A ? will flash. Press the + and – keys to select
the desired parameter.
>>Paper weight
? Normal
Press the CANCEL key if you want to cancel the setting. The ? will disappear.
4.
Pressing the ENTER key will cause the ? to disappear. Pressing the EXIT key will exit the setting.
The same procedure can be used to set the parameters on other submenus.
Note that the setting status for paper weight and fuser mode used for each paper type is as given in the table
below. In addition, all paper type settings made using Type adjust can be reset to the default values
shown in the table below using the >Reset type adjust menu.
Trans-
Plain
parency*
Normal
O
Paper
weight
Heavy
(Thick)
: These cannot be selected when the paper source is EF-100.
*
: These paper types will cause slower printing when the paper is fed from the MP tray.
**
Selection parameters
Normal (default)
Heavy (Thick)
Enable (default)
Disable
(Example: Setup menu for Paper weight)
Pre-
Labels**
Bond
printed
O
O
O
O
Sets the paper thickness
Selects duplex printing on/off when an optional
duplexer is installed (setting active only for the
selected paper type)
Paper Type
Letter-
Recycled Vellum* Rough**
head
O
O
O
2.8. Setting the Paper Type
Description
Pre-
Enve-
Color**
punched
lope**
O
O
O
O
Card
Custom
stock**
O
O
2-21
Advertisement
Table of Contents
