Supplying Toner - Mita DP-1400 Instruction Handbook Manual

4.1. Toner Kit Replacement

Supplying Toner

Before proceeding, take note of the following:
! Do not leave floppy disks etc. lying around while performing this maintenance procedure. This
procedure tends to raise a little toner dust which can harm magnetic recording media.
! Do not attempt to reuse the waste toner remaining in the toner container.
! Use only the toner kit exclusively designed for the printer. Use of a toner kit intended for use with
other printer models may damage the printer and void the warranty.
To replace the toner container, proceed as follows.
1.
Open the printer's top cover all the way.
2.
Press the toner container release lever (Green) to
release the old toner container from the printer.
Remove the old toner container as gently as possible.
Keep the toner container as level as possible while
removing.
3.
Put the old toner container in the plastic bag sup-
plied with the toner kit. Dispose of the toner con-
tainer.
The old toner container may be incinerated with-
out the risk of generating harmful gas.
CAUTION
Do not incinerate toner and toner containers. Dangerous sparks
may cause burn.
4.
Take the new toner container from its bag.
With the label side down, thoroughly shake the toner
container (in the direction of the arrow) ten times or
more to loosen and mix the toner inside.
5.
The bottom of the toner container is sealed with a
plastic strip. Carefully pull the sealing strip off the
toner container, making sure not to leak any toner.
Dispose of the sealing strip.
4-2
Plastic Bag
Top Cover
Old Toner
Container
Toner Container
Release Lever (Green)
Old Toner Container
New Toner Container
Sealing Strip