Table of Contents
Advertisement
2.13. Resource Protection
2.13. Resource Protection
When you switch from the HP LaserJet emulation to another, all downloaded fonts and macros are lost.
Resource protection preserves these PCL resources in memory so that they are intact when you change the
emulation back to PCL 6.
By using the printer's MODE SELECT, you can select from two resource protection modes as follows:
>Resource prot.
Permanent
In this mode, the printer stores fonts, macros, symbol sets, etc. in memory that were downloaded as perma-
nent PCL resources. All temporary resources are lost when the emulation mode is changed from PCL 6 to
another or vice versa.
>Resource prot.
Perm / Temp
In this mode, the printer stores both permanent and temporary resources when the emulation mode is
changed from PCL 6 to another or vice versa.
Resource protection requires extra memory to store the downloaded fonts and macros. The total
size of the printer memory recommended for using the resource protection option is affected by
several factors. See section 1.7. Memory Expansion Installation.
2.14. Adjusting the Print Density
If necessary, the print density can be adjusted from the MODE SELECT MENU. Density can be adjusted in
five steps from 01 (light) to 05 (dark). The factory setting is 03, and there is normally no need to alter this
setting.
When using the KIR function, please use the " 03" setting.
2-26
Advertisement
Table of Contents
