Power Cords - HP ML350T06 - E5520 Sff Us Svr Setup And Installation Manual

Regulatory Compliance Notices

Power Cords

If you were not provided with a power cord for the server, you should purchase a
power cord that is approved for use in your country.
The power cord must be rated for the product and for the voltage and current marked
on the product electrical ratings label. The voltage and current rating of the cord
should be greater than the voltage and current rating marked on the product. In
addition, the diameter of the wire must be a minimum of 1.00 mm² or 18 AWG, and
the length of the cord must be between 1.8 m (6 ft) and 3.6 m (12 ft). If you have
questions about the type of power cord to use, contact your HP authorized service
provider.
A power cord should be routed so that it is not likely to be walked on or pinched by
items placed upon it or against it. Particular attention should be paid to the plug,
electrical outlet, and the point where the cord exits from the product.
A-10 HP ProLiant ML350 Generation 3 Server Setup and Installation Guide