Removing A Processor - HP ML350T06 - E5520 Sff Us Svr Setup And Installation Manual

Hardware Options Installation

Removing a Processor

To remove a processor:
1. Remove the access panel by following the steps in the section applicable to your
tower or rack server earlier in this chapter.
2. Remove the fan baffle by performing the steps in "Removing the Fan Baffle"
earlier in this chapter.
3. Locate the processors and PPMs, as shown in Figure 3-28 and Table 3-4.
4. Pull up on the processor cage retaining bracket latch.
Figure 3-37: Pulling up the processor cage retaining
bracket latch
3-42 HP ProLiant ML350 Generation 3 Server Setup and Installation Guide