Removing The Access Panel In A Tower Server - HP ML350T06 - E5520 Sff Us Svr Setup And Installation Manual

4. To remove the bezel, lift the bezel upward, and pull it away from the chassis.
Figure 3-3: Removing the bezel
5. To replace the bezel, reverse the above procedure.
NOTE: When replacing the bezel, be sure that the bottom hinge points are properly placed in
the chassis before rotating the bezel back into its original position.

Removing the Access Panel in a Tower Server

WARNING: To reduce the risk of personal injury from hot surfaces, allow the
internal system components to cool before touching them.
CAUTION: To prevent damage to equipment or loss of data, be sure that the server
is powered down, all cables are disconnected from the back of the server, and the
power cord is disconnected from the grounded (earthed) AC outlet before removing
the access panel.
CAUTION: Do not operate the server when the large access panel is removed. This
panel is an integral part of the cooling system and removing it while the system is
running may adversely affect data integrity.
HP ProLiant ML350 Generation 3 Server Setup and Installation Guide
Hardware Options Installation
3-5