Remote Access Code; Message Alert Tone - AT&T EL52201 User Manual

Answering system
Answering system settings

remote access code

To access your answering system remotely from any touch-tone telephone,
you need to enter a two-digit number (00-99). Unless you change it, the
remote access code is 19.
To change the remote access code:
1. Press mENu/
2. Press or
CID
/sELECT.
mENu
3. Press or
CID
/sELECT.
press
mENu
4. Press or
CID
/sELECT.
press
mENu
5. Press or
CID
keys to enter the correct number (00-99).
6. Press /sELECT to save your setting. A confirmation tone sounds.
mENu
note: For more details about the remote access feature, refer to remote access on page 52.

message alert tone

When the message alert tone is on, and there is at least one new message,
the telephone base beeps every 10 seconds. By default, the message alert
tone is set to OFF.
To change the setting:
Follow Steps 1-3 in remote access code above.
1.
2. Press or
CID
/sELECT.
press
mENu
3. Press or
CID
4. Press /sELECT to save your setting. A confirmation
mENu
tone sounds.
notes:
• The message alert tone beeps only if all the conditions below are met:
– The answering system is on.
– The message alert tone is on.
– There are new messages.
To temporarily turn off the message alert tone, see Temporarily turn off the message alert
•
tone on page 46.
in idle mode to enter the main menu.
sELECT
to scroll to >ANsWErING sys, then press
DIr
to scroll to >ANs sys sETup, then
DIr
to scroll to >rEmOTE CODE, then
DIr
to select the remote access code, or use the dialing
DIr
to scroll to >msG ALErT TONE, then
DIr
to choose between >ON and >OFF.
DIr
42
REMOTE CODE
19
MSG ALERT TONE
>OFF