Installation Install the telephone base close to a telephone jack and a power outlet not controlled by a wall switch. For optimum range and better reception, place the telephone base in a central and open location. If you subscribe to high-speed Internet service (digital subscriber line - DSL) through your telephone line, you must install a DSL filter between the telephone line cord and the telephone wall jack (see the following page).
Battery installation & charging Install the battery as shown on the next page. Once you have installed the battery, the screen indicates the battery status (see table below). If necessary, place the handset in the telephone base or charger to charge the battery. For best performance, keep the handset in the charger when not in use.
Page 4
Battery installation & charging CHARGE light Step 2 Step 3 Step 1 Align the cover flat Plug the battery connector Charge the handset by against the battery placing it face up in the securely into the socket compartment, then inside the handset battery telephone base or slide it upwards charger.
Telephone base & charger installation Install the telephone as shown below. The telephone base is ready for table use. 5. Plug the other end of the telephone If you have DSL high speed Internet service, a DSL filter line cord into a (not included) is required.
Quick reference guide - handset CID/VOLUME Press CID to show caller ID CHARGE light information when the phone is The charge light is on when the not in use. handset is charging. Press to scroll down while in menus. Press VOLUME to decrease the volume level DIR/VOLUME...
Quick reference guide - telephone base VOICEMAIL indicator IN USE indicator Flashes when you have new voicemail. On when the handset is Voicemail service is in use or when the offered by your local answering system is telephone company, and answering an incoming is different from call.