Remote Access - AT&T TL76108 - 5.8GHz Digital Corded/Cordless Answering System User Manual

Answering system
NOTES:
1. If a valid remote access
code is not entered,
the call will disconnect
automatically.
2. If you pause for more
than four seconds during
remote access, you will
hear "For help, press 5."
This announcement will
be made three times. If
there is no command for
another four seconds, the
call will end automatically.
3. If you want to delete all
messages remotely, press
3 and the mailbox (1 or 2)
in remote standby mode
to delete them.
4. If the memory is full,
after 10 rings the
answering system will
answer and announce
"Please enter the remote
access code." Enter your
remote access code for
access to messages and
announcements.

Remote access

You can access your answering system remotely
by dialing your home telephone number from any
touch-tone telephone.
To remotely access your answering system:
1. Dial your telephone number from any touch-
tone telephone.
2. When the system answers, enter the four- digit
remote access code (5000 is the default code,
see page 60 to change it).
• If you have new messages, the system will
automatically announce the number of new
messages and then begin to play them.
3. You can also enter the following remote
commands.
Remote commands
Command
1 2
or
and the
mailbox (1 or 2)
3
3
and the
mailbox (1 or 2)
4
5
6
7
and the
mailbox (1 or 2)
67
Description
Play all messages: Press 1 and
the mailbox number.
Play new message: Press 2 and
the mailbox number.
Press to delete current message
during playback.
Press to delete all messages
(including new messages) in the including new messages) in the
selected mailbox.
Press to repeat the current
message. Press twice to hear
the previous message.
Press to hear a list of remote
commands.
Press to stop any operation
(including recording).
Press to skip to the next
message during playback.
Press to review the current
announcement of the selected
mailbox.
in the