Telephone Base Installation (2-Line Jack) - AT&T TL76108 - 5.8GHz Digital Corded/Cordless Answering System User Manual

Getting started

Telephone base installation (2-line jack)

If you subscribe to high-speed Internet service (Digital Subscriber Line - DSL)
through your telephone lines, you must install a DSL filter between the
telephone base and the telephone wall jack. The filter will prevent noise
and caller ID problems caused by DSL interference. Please contact your DSL
service provider for more information about DSL filters.
The telephone line cord can be plugged into LINE 1/L1+L2 or LINE 2
telephone jack in the telephone base. However, you are suggested to plug the
telephone line cord with 2 telephone numbers into LINE 1/L1+L2 telephone
jack if you are intended to connect the telephone to a fax machine or modem
through the DATA port.
If you have a 2-line wall jack, install the telephone base as shown below.
Telephone base installation
1. Plug the small end
of the telephone
base power adapter
into the power jack
at the bottom of the
telephone base.
IMPORTANT INFORMATION
1. Use only the power adapters supplied with this product or equivalent. To order a replacement
power adapter, visit our website at
1 (800) 222-3111
2. These power adapters are intended to be correctly oriented in a vertical or floor mount position.
The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-the-
table or cabinet outlet.
2. Plug the telephone
base power adapter
into an electrical
outlet not controlled
by a wall switch.
Line 1+Line 2
DSL filter (not included,
Telephone
required for DSL users).
line cord
www.telephones.att.com
1 (866) 288-4268
. In Canada, dial
6
3. Plug one end of the
telephone line cord into the
LINE 1/L1+L2 telephone
jack at the bottom of the
telephone base.
4. Plug the other
end of the
telephone line
cord into a 2 line
telephone jack.
5. Plug the other
end of the coiled
handset cord into
the jack at the
bottom of the
telephone base
and route the cord
through the slots.
, or call
.