Displaying The Module Information; Displaying The Switch Fabric Module Redundancy Status; Displaying Fabric Channel Switching Modes - Cisco 7604 Configuration Manual

Chapter 6 Configuring the Supervisor Engine 2 and the Switch Fabric Module

Displaying the Module Information

To display the module information, perform this task:
Command
Router# show module {5 | 6 | 7 | 8}
This example shows how to display module information:
Router# show module 5
Mod Ports Card Type
--- ----- -------------------------------------- ------------------ -----------
5
Mod MAC addresses
--- ---------------------------------- ------ ------------ ------------ -------
5

Displaying the Switch Fabric Module Redundancy Status

To display the switch fabric module redundancy status, perform this task:
Command
Router# show fabric active
This example shows how to display the switch fabric module redundancy status:
Router# show fabric active
Active fabric card in slot 5
No backup fabric card in the system
Router#

Displaying Fabric Channel Switching Modes

To display the fabric channel switching mode of one or all modules, perform this task:
Command
Router# show fabric switching-mode [module
{ | all]
slot_number
This example shows how to display the fabric channel switching mode of all modules:
Router# show fabric switching-mode all
bus-only mode is allowed
Module Slot
1
2
3
4
5
6
OL-4266-08
0 Switching Fabric Module
0001.0002.0003 to 0001.0002.0003
Switching Mode
Bus
Bus
DCEF
DCEF
No Interfaces
DCEF
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
Purpose
Displays module information.
Model
WS-C6500-SFM
Hw Fw
1.0 6.1(3)
Purpose
Displays switch fabric module redundancy status.
Purpose
Displays fabric channel switching mode of one or all
modules.
Monitoring the Switch Fabric Module
Serial No.
SAD04420JR5
Sw Status
6.2(0.97) Ok
6-7