Configuring Ip Unicast Layer 3 Switching - Cisco 7604 Configuration Manual

Configuring IP Unicast Layer 3 Switching

This chapter describes how to configure IP unicast Layer 3 switching on the Cisco 7600 series routers.
For complete syntax and usage information for the commands used in this chapter, refer to these
Note
publications:
The Cisco IOS Master Command List, Release 12.2SX at this URL:
•
http://www.cisco.com/en/US/docs/ios/mcl/122sxmcl/12_2sx_mcl_book.html
• The Release 12.2 publications at this URL:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_installation_and_configuratio
n_guides_list.html
IPX traffic is fast switched on the MSFC. For more information, refer to this URL:
•
http://www.cisco.com/en/US/docs/ios/12_2/atipx/configuration/guide/fatipx_c.html
For information about IP multicast Layer 3 switching, see
•
Layer 3 Switching."
This chapter consists of these sections:
• Understanding How Layer 3 Switching Works, page 26-2
Default Hardware Layer 3 Switching Configuration, page 26-4
•
Configuration Guidelines and Restrictions, page 26-4
•
Configuring Hardware Layer 3 Switching, page 26-5
•
Displaying Hardware Layer 3 Switching Statistics, page 26-6
•
For additional information (including configuration examples and troubleshooting information), see the
Tip
documents listed on this page:
http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html
OL-4266-08
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
C H A P T E R
Chapter 28, "Configuring IPv4 Multicast
26
26-1