Performing Memory Tests - Cisco 7604 Configuration Manual

Performing Memory Tests

Performing Memory Tests
Most online diagnostic tests do not need any special setup or configuration. However, the memory tests,
which include the TestFibTcamSSRAM and TestLinecardMemory tests, have some required tasks and
some recommended tasks that you should complete before running them.
Before you run any of the online diagnostic memory tests, perform the following tasks:
•
•
Tip For additional information (including configuration examples and troubleshooting information), see the
documents listed on this page:
http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
55-10
Required tasks
Isolate network traffic by disabling all connected ports.
–
Do not send test packets during a memory test.
–
Reset the system before returning the system to normal operating mode.
–
Turn off all background health monitoring tests using the no diagnostic monitor module 1 test all
command.
Chapter 55 Configuring Generic Online Diagnostics
OL-4266-08