Copying Files to the Redundant Supervisor Engine
Synchronizing the Supervisor Engine Configurations
During normal operation, the startup-config and config-registers configurations are synchronized by
default between the two supervisor engines. In a switchover, the new active supervisor engine uses the
current configuration.
Copying Files to the Redundant Supervisor Engine
Enter this command to copy a file to the disk0: device on a redundant supervisor engine:
Router# copy source_device : source_filename slavedisk0: target_filename
Enter this command to copy a file to the bootflash: device on a redundant supervisor engine:
Router# copy source_device : source_filename slavesup-bootflash: target_filename
Enter this command to copy a file to the bootflash: device on a redundant MSFC:
Router# copy source_device : source_filename slavebootflash: target_filename
For additional information (including configuration examples and troubleshooting information), see the
Tip
documents listed on this page:
http://www.cisco.com/en/US/products/hw/routers/ps368/tsd_products_support_series_home.html
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
7-20
Chapter 7
Configuring NSF with SSO Supervisor Engine Redundancy
OL-4266-08