Configuring The Igmp Snooping Query Interval - Cisco 7604 Configuration Manual

Chapter 30 Configuring IGMP Snooping for IPv4 Multicast Traffic
Configuring a Static Connection to a Multicast Receiver
To configure a static connection to a multicast receiver, perform this task:
Command
Step 1
Router(config)# mac-address-table static mac_addr
vlan vlan_id interface type
[disable-snooping]
Router(config)# no mac-address-table static
mac_addr vlan vlan_id
Step 2
Router(config-if)# end
Step 3
Router# show mac-address-table address mac_addr
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
When you configure a static connection, enter the disable-snooping keyword to prevent multicast traffic
addressed to the statically configured multicast MAC address from also being sent to other ports in the
same VLAN.
This example shows how to configure a static connection to a multicast receiver:
Router(config)# mac-address-table static 0050.3e8d.6400 vlan 12 interface fastethernet 5/7
Configuring a Multicast Router Port Statically
To configure a static connection to a multicast router, perform this task:
Command
Step 1
Router(config-if)# ip igmp snooping mrouter
1
interface type
Step 2
Router(config-if)# end
Step 3
Router# show ip igmp snooping mrouter
1. type = ethernet, fastethernet, gigabitethernet, or tengigabitethernet
The interface to the router must be in the VLAN where you are entering the command, the interface must
be administratively up, and the line protocol must be up.
This example shows how to configure a static connection to a multicast router:
Router(config-if)# ip igmp snooping mrouter interface fastethernet 5/6
Router(config-if)#

Configuring the IGMP Snooping Query Interval

You can configure the interval for which the router waits after sending a group-specific query to
determine if hosts are still interested in a specific multicast group.
When both IGMP fast-leave processing and the IGMP query interval are configured, fast-leave
Note
processing takes precedence.
OL-4266-08
1
slot/port
slot/port
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
Purpose
Configures a static connection to a multicast receiver.
Clears a static connection to a multicast receiver.
Exits configuration mode.
Verifies the configuration.
Purpose
Configures a static connection to a multicast router.
Exits configuration mode.
Verifies the configuration.
Configuring IGMP Snooping
30-11