Cisco 7604 Configuration Manual page 971

Appendix A Online Diagnostic Tests
TestQoSTcam, page A-30
Because the supervisor engine must be rebooted after running memory tests, run memory tests on the
Note
other modules before running them on the supervisor engine. For more information about running
on-demand online diagnostic tests see the
page
TestFibTcamSSRAM
The TestFibTcamSSRAM test checks the FIB TCAM and Layer 3 Adjacency SSRAM memory.
Table A-51
Attribute
Disruptive/Nondisruptive
Recommendation
Default
Release
Corrective action
Hardware support
TestAsicMemory
The TestAsicMemory test uses an algorithm to test the memory on a module.
Table A-52
Attribute
Disruptive/Nondisruptive
Recommendation
Default
Release
Corrective action
Hardware support
OL-4266-08
55-3.
TestFibTcamSSRAM Test Attributes
TestAsicMemory Test Attributes
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
"Configuring On-Demand Online Diagnostics" section on
Description
Disruptive. Disruption is several hours.
Use this test only if you suspect a problem with the hardware
or before putting the hardware into a live network. Do not run
any traffic in the background on the module that you are
testing. The supervisor engine must be rebooted after running
this test.
Off.
12.1(20)E, 12.2(14)SX, 12.2(17a)SX.
Not applicable.
All modules including supervisor engines.
Description
Disruptive. Disruption is approximately one hour.
Use this test only if you suspect a problem with the hardware
or before putting the hardware into a live network. Do not run
any traffic in the background on the module that you are
testing. The supervisor engine must be rebooted after running
this test.
Off.
12.2(17a)SX.
Not applicable.
All modules including supervisor engines.
Exhaustive Memory Tests
A-29