Cisco 7604 Configuration Manual page 185

Chapter 13 Configuring VTP
Configuring the VTP Mode
To configure the VTP mode, perform this task:
Command
Step 1
Router(config)# vtp mode {client | server |
transparent}
Router(config)# no vtp mode
Step 2
Router(config)# vtp domain domain_name
Step 3
Router(config)# end
Step 4
Router# show vtp status
In VTP transparent mode, the VLAN configuration is stored in the startup configuration file.
Note
This example shows how to configure the router as a VTP server:
Router# configuration terminal
Router(config)# vtp mode server
Setting device to VTP SERVER mode.
Router(config)# vtp domain Lab_Network
Setting VTP domain name to Lab_Network
Router(config)# end
Router#
This example shows how to verify the configuration:
Router# show vtp status
VTP Version
Configuration Revision
Maximum VLANs supported locally : 1005
Number of existing VLANs
VTP Operating Mode
VTP Domain Name
VTP Pruning Mode
VTP V2 Mode
VTP Traps Generation
MD5 digest
Configuration last modified by 0.0.0.0 at 8-12-99 15:04:49
Local updater ID is 172.20.52.34 on interface Gi1/1 (first interface found)
Router#
This example shows how to configure the router as a VTP client:
Router# configuration terminal
Router(config)# vtp mode client
Setting device to VTP CLIENT mode.
Router(config)# exit
Router#
OL-4266-08
Purpose
Configures the VTP mode.
Reverts to the default VTP mode (server).
(Optional for server mode) Defines the VTP domain
name, which can be up to 32 characters long. VTP server
mode requires a domain name. If the router has a trunk
connection to a VTP domain, the router learns the domain
name from the VTP server in the domain.
Note
Exits VLAN configuration mode.
Verifies the configuration.
: 2
: 247
: 33
: Server
: Lab_Network
: Enabled
: Disabled
: Disabled
: 0x45 0x52 0xB6 0xFD 0x63 0xC8 0x49 0x80
Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX
You cannot clear the domain name.
Configuring VTP
13-9