Hardware Diagnostic Testing; Verifying Proper Operation Of Key System Lights; Confirming Loading Of The Operating System - Intel SE7320VP2 User Manual

User guide
Table of Contents

Advertisement

Hardware Diagnostic Testing

This section provides a more detailed approach to identifying a hardware problem and locating its
source.
CAUTION
Turn off devices before disconnecting cables: Before disconnecting any
peripheral cables from the system, turn off the system and any external
peripheral devices. Failure to do so can cause permanent damage to the
system and/or the peripheral devices.
1. Turn off the system and all external peripheral devices. Disconnect each of device from the
system, except for the keyboard and the video monitor.
2. Make sure the system power cord is plugged into a properly grounded AC outlet.
3. Make sure your video display monitor and keyboard are correctly connected to the system.
Turn on the video monitor. Set its brightness and contrast controls to at least two thirds of their
maximum ranges (see the documentation supplied with your video display monitor).
4. If the operating system normally loads from the hard disk drive, make sure there is no diskette
in drive A and no CD-ROM disk in the CD-ROM drive.
5. If the power LED does light, attempt to boot from a floppy diskette or from a CD-ROM disk.
6. Turn on the system. If the power LED does not light, see

Verifying Proper Operation of Key System Lights

As POST determines the system configuration, it tests for the presence of each mass storage device
installed in the system. As each device is checked, its activity light should turn on briefly. Check
for the following:
Does the diskette drive activity light turn on briefly? If not, see
Does Not
Light."
If system LEDs are illuminated, see
to take to correct the problem.

Confirming Loading of the Operating System

Once the system boots up, the operating system prompt appears on the screen. The prompt varies
according to the operating system. If the operating system prompt does not appear, see
Characters Appear on
"LED
Screen."
"Power Light Does Not
"Diskette Drive Activity Light
Information" for a description of the light and steps
Troubleshooting
Light."
"No
41

Advertisement

Table of Contents
loading

This manual is also suitable for:

Se7320vp2d2

Table of Contents