Table of Contents
Advertisement
Server Board Features
Hardware Requirements
To avoid integration difficulties and possible board damage, your system must meet the
requirements outlined below. For a list of qualified components, see the links under
Information and
Software."
Processor
One or two Intel® Xeon™ processors with an 800MHz front side bus and a minimum of 2.8 GHz
frequency must be installed. The following table outlines the supported processors. For a complete
list of supported processors, see the links under
Table 6.
Processor Support
Processor Family
Intel® Xeon™
Intel® Xeon™
Intel® Xeon™
Intel® Xeon™
Intel® Xeon™
Memory
The Server Board SE7320VP2 provides six DIMM sockets across two channels, Channel A and
Channel B. Channel A consists of DIMM sockets 1A, 2A, and 3A. Channel B consists of DIMM
sockets 1B, 2B, and 3B.
If six DIMMs are installed, the following maximum capacitites are possible:
For DDR266 DIMMS: Maxixmum capacity of 24GB
For DDR333 DIMMS: Maximum capacity of 16 GB
A minimum of one 256MB DIMM is required in DIMM socket 1A. This uses single-channel
interleave. However, for dual-channel interleave, providing optimum performance, a minimum
of two DIMMs should be installed in DIMM sockets 1A and 1B. Except for the option of
installing a single DIMM in socket 1A, DIMMs must be installed in pairs and populated as
follows:
DIMM1A and DIMM 1B: Populate these two sockets together first
DIMM 2A and DIMM 2B: Populate these sockets in addition to DIMM 1A and DIMM 2A if
four DIMMs are to be used.
DIMM 3A and DIMM 3B: Populate these sockets after DIMM 1A, DIMM 1B, DIMM 2A, and
DIMM 2B have been populated.
22
"Additional Information and
FSB Frequency
800 MHz
800 MHz
800 MHz
800 MHz
800 MHz
Frequency
2.8 GHz
3.0 GHz
3.2 GHz
3.4 GHz
3.6 GHz
"Additional
Software."
Advertisement
Table of Contents
