Advanced > Management > Maintenance Notification > Sending Log History - Kyocera TASKalfa 8000i User Manual

Kyocera command center rx user guide rev-1.2
Hide thumbs Also See for TASKalfa 8000i:
Table of Contents

Advertisement

Advanced > Management > Maintenance Notification > Sending
Log History
COMMAND CENTER RX
Subject
You can include model name, serial number, MAC address and equipment
ID in the subject line as follows: Enter one of the following conversion strings
starting with %. The string will be converted into a pre-defined string to
display the above information.
• %printer = Model
• %serial = Serial Number
• %etheraddr = MAC Address
• %equipid = Equipment ID
E-mail Interval
Sets the time or interval for sending the status information. Events will be
reported at the specified interval.
• None: No report is sent.
• Monthly: Sends on the specified time of specified month.
• Weekly: Sends on the specified time of every week.
• Daily: Sends at the specified time of every day.
• Hourly: Sends at the specified interval every hour.
If a specified day does not exist in the month, such as the 31st, the last day
of the month is used as the specified day.
Run once now
You can test this by clicking the Send button to immediately send a report.
This feature defines the Job Log Notification information reports.
Recipient Address
The E-mail address of the recipient. If there is more than one recipient then
the addresses should be separated by a semicolon ";".
Job Log Subject
You can include model name, serial number, and MAC address in the
subject line as follows: Enter one of the following conversion strings starting
with %. The string will be converted into a pre-defined string to display the
above information.
• %printer = Model
• %serial = Serial Number
• %etheraddr = MAC Address
SSFC Job Log Subject
Defines the Job Log Notification information reports only when you log in by
using a SSFC-format IC card. You can include the same information as
above. (This menu available when an optional IC-card reader is installed
with the printing system.)
Auto Sending
Determines whether the job log report is sent or not. Set this to On to send
the report.
Jobs
Settings Pages
6-45

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents