Start > Information; Basic Page; Basic > Defaults > Network - Kyocera TASKalfa 8000i User Manual

Settings Pages
Start > Information

Basic Page

Basic > Defaults > Network
6-4
This allows you to verify the accumulated number of printed pages for each
paper size and color (Monochrome, Mono Color, and Full Color). A page
printed on both sides is counted as two pages.
Counters > Scanned Pages
Provide information of the number of pages copied, faxed, and other
(scanned), respectively.
This page provides information about user account.
User Login
This shows the number of registered users. For details, see
> User Login on page 6-8.
This section includes settings that apply to the device, such as Device Defaults,
Security, and basic Networking.
This page allows you to make the settings that are required for network printing
and sending E-mail. For more information, refer to
TCP/IP > General on page 6-29.
You must restart this machine after you have completed these settings in order
to properly register the content of those settings in the machine. Refer to
> Defaults > Reset on page 6-6.
Host Name
Specifies a name for the printing system network component. This name is
used as the NetBEUI printer name and as the WSD device name.
LAN Interface
Specifies the communication rate from Auto, 10BASE-T-Half, 10BASE-T-
Full, 100BASE-TX-Half, 100BASE-TX-Full and 1000BASE-T. If you
change the communication rate, you must restart the machine in order to
make this setting valid.
IPv4 Settings
• DHCP/BOOTP
Specifies whether or not to obtain an IP address using DHCP or BOOTP.
• IP Address (IPv4)
Assigns the Internet Protocol address on the printing system network
component. Format of the IP address is four-byte (32-bit) numbers separated
by dots, for example, 192.168.110.171.
• Subnet Mask
Specifies the subnet mask of the hosts or network with which the print system
is connecting. If you have manually assigned an IP address that starts with a
number between 192 and 223, it is recommended that you set the subnet
mask to "255.255.255.0."
• Default Gateway
Specifies the IP address of the default gateway.
IPv6 Settings
Basic > Security
Advanced > Protocols >
User Guide
Basic