Sending And Receiving Ip Address Faxes; Tcp/Ip Settings; Ip Address Fax Function - Konica Minolta bizhub 751 User Manual

Setup items by operation
1.17

Sending and receiving IP address faxes

Specify settings for sending and receiving IP address faxes.
To use the IP address fax function, this machine must be equipped with an optional fax kit,a hard disk and
an image controller. In order to use the IP address fax function, setting by a service engineer is required. For
details, contact your service representative.
The IP address fax enables communication on the IP network. Specify the host name or IP address for the
destination to send a Fax. SMTP protocol is used for sending and receiving faxes. Because IP address faxes
are sent and received via the SMTP server function of this machine, no SMTP server is required.
Specify the settings according to the following flowchart.
Note
For details on registering IP address fax addresses, refer to
destination" on page
For details on the IP address fax operation, refer to the User's Guide [Network Scan/Fax/Network Fax
Operations].
1.17.1

TCP/IP Settings

Specify settings to use this machine in a TCP/IP network environment.
For details, refer to
1.17.2

IP Address Fax Function

On the Administrator Settings screen of the control panel, select [Network Settings] - [Forward] - [3 Network
Fax Setting] - [1 Network Fax Function Setting].
Specify the following setting.
Note
For details on displaying the Network Setting screen, refer to
screen" on page
751/601
TCP/IP Settings
IP Address Fax Function
SMTP TX Setting
SMTP RX Setting
Header Information
Finish
1-168.
"Specifying general settings for TCP/IP-based communication" on page
2-2.
"Registering or editing an address book
"Displaying the Network Settings
1
1-2.
1-59