Action For Invalid Certificate - Konica Minolta bizhub 751 User Manual

Setup items by operation
Item
User ID
Protocol
Encryption Strength
Validity Period
CA Certificate
Server ID
Server ID
CA Certificates rote
Client Certificates
Network Stop Time
Stop Time
1.43.5

Action for Invalid Certificate

Configure the action of this machine that is taken when the certificate is invalid.
For details, refer to
751/601
Definition
Enter a user ID to be used for EAP-TTLS authentication (up
to 128 characters).
This item is available if "EAP-Type" is set to "EAP-TTLS" or
"Depend on Server".
Select an EAP-TTLS inner authentication protocol.
This item is available if "EAP-Type" is set to "EAP-TTLS" or
"Depend on Server".
Select an encryption strength level for encrypted communi-
cation with TLS.
- Low: Keys of any length are used for communication.
- Mid: Keys that are more than 56 bits in length are used for
communication.
- High: Keys that are more than 128 bits in length are used
for communication.
This item is available if "EAP-Type" is set to anything other
than "OFF" or "EAP-MD5".
Select whether to check that the server certificate is within
the validity period.
Select whether to check that the server certificate chain (cer-
tification path) is correct.
A checking of the chain is made by reference to the route CA
certificate registered on this machine. For details, refer to
"Installation of CA Certificate" on page
Select whether to check that the CN of the server certificate
matches the server address.
To check the server ID, specify "Server ID".
Enter a server ID (up to 64 characters).
This setting is required if you verify the CN of the server cer-
tificate.
An indication is made to see if the route CA certificate is in-
stalled.
When the CA reliability of the server certificate is checked,
this is required to be installed. For details of the method for
installation, refer to "Installation of CA Certificate" on
page 1-132.
Use the client certificate of this machine to make a selection
to decide whether or not the authentication information is
encrypted. When the client certificate is installed in this ma-
chine, a setting can be made. When [EAP-TLS] is selected
for EAP-Type, the client certificate is indispensable. When
EAP-Type is [EAP-TTLS] or [PEAP], a setting can also be
made.
If an authentication process does not succeed within the
specified time, all network communication will stop. To
specify the delay between the start of an authentication
process and the stopping of network communication, select
this box.
Specify the delay (sec.) between the start of an authentica-
tion process and the stopping of network communication.
To restart the authentication process after network commu-
nication has stopped, turn the main power of this machine
off and on again.
"Action for Invalid Certificate" on page
Prior confirmation
1-132.
Whether to verify the CN
of the server certificate
Is the CA reliability of the
server certificate
checked?
1-134.
1
1-134