Xerox 4110 User Manual page 90

4. W i n do w s 2 00 0 /X P a n d W i nd ow s S e r v e r 2 00 3
Paper Size
Paper Source
Paper Type
2-sided Print
Stapling
4- 2 0
NOTE: The Collated setting must be selected in the Page Setup
tab when using Print Type.
• Delayed Print - Delayed Print temporarily stores print jobs in
the printer, and then prints them at the scheduled time. Select
when you want to output delayed prints.
See the On-line Help for details on the operation of the printer.
– Start Print Time - Specifies the time when a Delayed Print
job will be printed. Place the cursor in the hour or minute
box and press the up or down triangle to specify the start
time. You can also set the time by entering the time directly
into the boxes. The default setting is 00:00.
Select the paper size of the file to be printed.
Select the paper tray to be used for printing.
Select the paper type to be used for printing.
Performs 2-sided printing. Select either "Flip on long edge" or
"Flip on short edge" for 2-sided printing. Select any one of these
options as required. In "Flip on long edge" and "Flip on short
edge," the side 1 and side 2 images are printed such that when
rotated with the long edge and short edge respectively as axis,
they are pointing in the same direction.
Select the stapling position. The stapling position specified is
based on the printing data. If the stapling position is incorrect,
refer to the PostScript Kit manual and adjust the Stapling setting
accordingly.
NOTE: Limitations for stapling mixed size output may apply.
Stapling for mixed size output is not available in the following
situations:
• When a setting other than "1 Up" is selected for "Multiple-Up"
in the "Layout" tab
• When a setting other than "Off" is selected for "Booklet
Creation" in the "Layout" tab
• When "Double Print" is set to "On" under "Details" in the
"Detailed Settings" tab
• When a size other than "A3," "B4," "A4," "B5," "8.5 x 11," "11 x
17," "16K (267 x 194mm) / 8K (267 x 388mm)," and "16K (270
x 195mm) / 8K (270 x 390mm)" is selected
• When a setting other than "None" or "On (Mixed Sizes)" is
selected for "Hole Punching" in the "Paper / Output" tab
X e r o x 4 11 0/ 4 59 0 P os t S c r i pt U s er G ui d e