Xerox 4110 User Manual page 111

Offset Stacking
Collated
Feed Separators from
Print on Separators
Front Cover
Back Cover
Tray 8 - Specify Tab Stock
Stapling
Hole Punching
Hole Punching
X er o x 4 110 /4 5 90 P o s tS c r i p t Us e r G ui d e
Settings
This section describes the settings in the Printer Specific Options
list. The settings that can be selected vary depending on which
options have been installed. Make these settings after specifying
the installed options in Configure.
11.
The position of individual jobs or sets of copies are shifted to either
side of the output tray to enable easy separation.
Selects whether to collate a multiple-page file per set when they
are printed.
Specifies the paper tray that transparency dividers are to be fed
from. When [Auto] is selected, the tray set on the machine is used
as the feed destination.
Specifies whether or not to print on the transparency dividers as
well as the transparency.
Specify whether to add front cover to the printouts. Select the
paper tray for feeding the front cover sheets.
Specify whether to add back cover to the printouts. Select the
paper tray for feeding the back cover sheets.
Specifies whether tab stock is being loaded in tray 8. Select either
"Plain" or "Tab Stock."
Specifies whether or not to staple printed documents and the
position of the staple. You can staple 2 to 50 sheets of 80 g/m
lighter paper.
Select the punching position. The holes are made based on the
output orientation of the paper. As a result, the holes may not be
punched correctly depending on the position of the image.
Specify the number of holes to punch. Select from "Use Printer
Settings," "2 Holes," or "4 Holes." If "3 Holes" is selected for "Hole
Puncher Setup," only "Use Printer Settings" will be available for
selection.
5 . M ac i n to s h c om p ut e r s
See "Printer options" on page 5-
2
or
5-15