Offset Stacking
Collated
Feed Separators from
Print on Separators
Front Cover
Back Cover
Tray 8 - Specify Tab Stock
Stapling
Hole Punching
X er o x 4 110 /4 5 90 P o s tS c r i p t Us e r G ui d e
Feature List
The position of individual jobs or sets of copies are shifted to either
side of the output tray to enable easy separation.
Selects whether to collate a multiple-page file per set when they
are printed.
Specifies the paper tray that transparency dividers are to be fed
from. When [Auto] is selected, the tray set on the machine is used
as the feed destination.
Specifies whether or not to print on the transparency dividers as
well as the transparency.
Specify whether to add a front cover to the printouts. Select the
paper tray for feeding the front cover sheets.
Specify whether to add a back cover to the printouts. Select the
paper tray for feeding the back cover sheets.
Specifies whether or not to print on the transparency dividers as
well as the transparency.
Specifies whether or not to staple printed documents and the
position of the staple. You can staple 2 to 50 sheets of 80 g/m
lighter paper.
NOTE: You cannot use staples in the following situations:
–
When anything other than Finisher Tray is selected for
Output Destination in the Advanced tab.
–
When Job Offset is selected.
Select the punching position.
The holes are made based on the output orientation of the
paper. As a result, the holes may not be punched correctly
depending on the position of the image.
2 . W i nd ow s M e
2
or
2-9