Xerox 4110 User Manual page 104

5. M a c i nt os h c o m pu t er s
5- 8
8.
Confirm the Install Location and change it if necessary, then
click [Install].
9.
Click [Quit].
This completes the installation.
Proceed to "Adding a Printer (Mac OS X)" on page 5-8 to
continue.
Adding a Printer (Mac OS X)
After the PPD file has been installed, set the PPD file for the printer
driver and then add the printer. The printer driver controls the
printer functions based on the information in the PPD file. Use the
following procedure to add a printer. This procedure uses
Macintosh OS X v10.2.8 as its example.
NOTE: Menu items and procedures may vary slightly for Mac OS
X v10.3.3 or other operating system versions.
1.
Check that the port on the Xerox 4110 Copier / Printer is set to
Enable.
• When using AppleTalk, set the EtherTalk port to Enable.
• When using IP Printing, set the LPD port to Enable.
You can check the EtherTalk and LPD settings in the System
Settings List. See the User Guide for details about how to print
the "System Settings List."
2.
Start [Print Center].
NOTE: You can find Print Center in the Utilities folder in the
Applications folder. For Mac OS X 10.3.3, open the Printer
Setup Utility in the Utilities folder in the Applications folder.
X e r o x 4 11 0/ 4 59 0 P os t S c r i pt U s er G ui d e