Table of Contents
Advertisement
www.gateway.com
Adding or replacing an optional diskette drive
Important
The color and shape of your replacement
drive's front cover may vary from your
original drive.
If you are replacing a drive, note any jumper settings on the old drive and
7
set the jumpers on the new drive to be the same. If you are installing a
new drive, follow the manufacturer's instructions.
Slide the new drive into the drive bay, line up the thumbscrew hole on
8
the drive bay with the screw hole on the drive, then slide the drive release
latch toward the front of the computer to lock the drive into place. You
do not need to replace the thumbscrew because it was originally installed
for shipping purposes.
Connect the drive cables using your notes from
9
a new drive, follow the manufacturer's instructions.
Replace the front bezel by following the instructions in
10
front bezel" on page
Replace the side panel by following the instructions in
11
panel" on page
15.
To add or replace a diskette drive:
Remove the side panel by following the instructions in
1
panel" on page
12.
Remove the front bezel by following the instructions in
2
front bezel" on page
If you are installing a new drive, go to
3
- OR -
If you are replacing an existing drive, disconnect the cables from the drive,
noting their locations and orientation. You will reconnect the cables after
you install the new drive.
Remove the thumbscrew from the diskette drive.
4
Adding or replacing an optional diskette drive
14.
14.
Step
7.
Thumbscrew
Step
3. If you are installing
"Replacing the
"Replacing the side
"Removing the side
"Removing the
19
Advertisement
Table of Contents
