Table of Contents
Advertisement
www.gateway.com
Do not touch the contacts on the bottom
part of the expansion card. Touching the
contacts can cause electrostatic damage
Place the heat sink over the processor, then tighten the screws that secure
18
it to the system board.
Align the notches on the memory modules with the notches on the
19
memory module banks and press the modules firmly into the banks. The
tabs on the sides of the memory modules should secure the memory
modules automatically. When a module is secure, you hear a click.
Caution
Install the expansion cards into the expansion slots. You can slightly
20
seesaw a card end-to-end to help insert the card, but do not bend the card
sideways.
to the card.
Reconnect the expansion card cables using your notes from
21
Install the fan cover.
22
Return your computer to its upright position.
23
Replace the side panel by following the instructions in
24
panel" on page
15.
Replacing the system board
Step
3.
"Replacing the side
35
Advertisement
Table of Contents
