www.gateway.com
Be careful not to catch the wires
connecting the power button to the
system board when rotating the fan
mount. A notch has been provided for
routing these wires.
Replacing the rear fan
Tips & Tricks
You need a Phillips screwdriver to replace
Caution
Insert the tabs on the rear of the fan mount into the slots provided, then
7
rotate the mount into place. The mount should lock into place.
Reconnect the fan cable to the system board.
8
Replace the fan cover.
9
Replace the side panel by following the instructions in
10
panel" on page
To replace the rear fan:
the rear fan.
Remove the side panel by following the instructions in
1
panel" on page
Disconnect the fan cable from the system board. The location of the fan
2
connection may vary, so trace the fan cable from the fan to the system
board.
15.
12.
Replacing the rear fan
"Replacing the side
"Removing the side
25