Loading Paper; Loading Paper In Tray 2, Tray 3, Tray 4, Or Tray 5 - Konica Minolta bizhub 36 User Manual

7.1 Paper
7.1.2

Loading paper

This section describes how to load paper into each tray.
If printing stops due to the tray being empty, load paper into the tray. Printing restarts automatically.
For the types of paper to be used, refer to page 10-2.

Loading paper in Tray 2, Tray 3, Tray 4, or Tray 5

The procedure for loading paper is common between Tray 2, Tray 3, Tray 4, and Tray 5.
The following procedure describes how to load paper into Tray 2.
0 Tray 4 and Tray 5 are optional.
0 The size of loaded paper is automatically detected.
1
Pull out Tray 2.
% 1. Film
NOTICE
Be careful not to touch the Film.
2
Slide the Lateral Guide to fit the size of paper being loaded.
% If the Lateral Guide are not positioned correctly for the loaded
paper, the paper size will not be correctly detected.
3
Load the paper into the tray so that the side of the paper to be
printed on (the side facing up when the package was unwrapped)
faces up.
% Do not load so many sheets of paper that the top of the stack
is higher than the , mark.
% If paper is curled, flatten it before loading it.
% If special paper is loaded, the paper type must be specified.
% Load letterhead paper so that the side to be printed on faces
up.
4
Close Tray 2.
d
Reference
To configure paper settings:
Press [Copy] or the Copy key ö [Paper].
bizhub 42/36
7
1
1
7-3