Finishing Error Detection - Kyocera KM-2540 Operation Manual

Selecting the Printer Settings
2
Press
Continue and press [Change #].
3 Press [On] or [Off].
When you have selected On, press
[+] or [-] or use the numeric keys to
enter the auto continue time.
The auto continue time can be
between 0 and 495 seconds, in 5-
second increments.
4 Press [Close] and returns to the Others screen.
5
Press [Close] and returns to the Printer menu screen.

Finishing Error Detection

If the error detection setting for duplex (staple) printing has been turned On, and you
attempt to print onto a paper size and paper type that cannot be used for duplex (staple)
printing, the error message will be displayed and printing will stop. To print onto one-side
(without staple) of the paper only when this message is displayed, press [GO]. The default
setting is Off.
Proces. Duplex
print
Staple Mode
1
Access Others, refer to Automatic Form Feed Timeout Setting on page 2-46.
2-48
or to select Auto
Mode
On Displays an error message.
Press [GO] to continue single side printing. Press [Cancel] to
cancel printing.
Off Continues 1-sided printing without showing an error message.
On Displays an error message.
Press [GO] to clear the error message and continue printing
without stapling. Press [Cancel] to cancel printing.
Off No error message is shown and printing continues without
stapling.
Others
Setting Item Value
Form Feed Time Out 30 Sec.
Resource Protect Permanent
Auto Continue Off
Finishing Error
Printer menu
Auto continue
When error occurs, auto timing for processing can be set.
(0 ~ 495)
30 Seconds
Off
(5)
On
(5)
Printer menu - Others
Description
Change # Service
Back