Kyocera KM-2540 Operation Manual page 51

NOTE:
The operations of the RAM disk are the same as those of the memory card. Refer
to the relevant sections Using the Memory Card on page 2-30.
Activating the RAM Disk
By default, the RAM disk is not activated (Off). To confirm the RAM disk size or activate the
RAM disk, proceed as follows:
1 Press the [Print] key. The machine enters the printer mode.
2
Press [Printer Menu].
3
Press [RAM DISK Mode].
4
Press [On].
5
Press [Close].
Do you want to restart immediately? is displayed.
6 Press [Yes].
The machine restarts and the RAM disk mode is enabled.
Setting the RAM Disk Size
To use the RAM disk, activate and enter the desired size of the RAM disk in the manner
described below. The maximum RAM disk size can be calculated as follows:
aximum RAM disk size = Total printer memory - 36MB
For example, if the total memory installed in your printer is 64MB, you can set 28MB of
RAM disk. If you attempt to set the RAM disk size beyond this restriction, the printer
automatically round it down so that the size is always 36MB less than the total printer
memory.
Selecting the Printer Settings
Select item.
Printer menu
Print Sta- Paper
Font
tus Page Handling
Interface Page Set
Print
RAM DISK
Emulation
Quality Mode
RAM DISK Mode
Read
Write Data
Off
List of
On Partitions
RAM Disk
Size
Printer menu
Others
Back
Delete
2-35