Igmp Snooping Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Command Reference Manual

Hp 1:10gb ethernet bl-c switch for c-class bladesystem command reference guide
Hide thumbs Also See for 438031-B21 - 1:10Gb Ethernet BL-c Switch:
Table of Contents

Advertisement

Table 142
IGMP Snoop Menu options
Command
on
off
cur

IGMP snooping configuration

Command: /cfg/l3/igmp/snoop
[IGMP Snoop Menu]
The following table describes the IGMP Snoop Configuration Menu options.
IGMP Snoop Menu options
Table 143
Command
igmpv3
timeout <1-255>
mrto <1-600>
qintrval <1-600>
robust <2-10>
flood disable|enable
aggr disable|enable
srcip <IP address>
Description
Globally turns IGMP on.
Globally turns IGMP off.
Displays the current IGMP configuration parameters.
igmpv3
- IGMP Version3 Snoop Menu
timeout
- Set report timeout
mrto
- Set multicast router timeout
qintrval - Set IGMP query interval
robust
- Set expected packet loss on subnet
flood
- Flood unregistered IPMC
aggr
- Aggregate IGMP report
srcip
- Set source ip to use when proxying GSQ
add
- Add VLAN(s) to IGMP Snooping
rem
- Remove VLAN(s) from IGMP Snooping
clear
- Remove all VLAN(s) from IGMP Snooping
fastlv
- Enable/disable Fastleave processing in VLAN
cur
- Display current IGMP Snooping configuration
Description
Displays the IGMPv3 Snooping menu.
Sets the Maximum Response Time (MRT) for IGMP hosts. MRT is one of the
parameters used to determine the age out period of the IGMP hosts. Increasing the
timeout increases the age out period.
The default is 10 seconds.
Configures the age-out period for the IGMP Mrouters in the Mrouter table. If the
switch does not receive a General Query from the Mrouter for mrto seconds, the
switch removes the multicast router from its Mrouter table.
The default is 255 seconds.
Sets the IGMP router query interval. The default value is 125.
Configures the IGMP Robustness variable, which allows you to tune the switch for
expected packet loss on the subnet. If the subnet is expected to be lossy (high rate
of packet loss), then increase the value. The default value is 2.
Configures the switch to flood unregistered IP multicast reports to all ports.
Enables or disables IGMP Membership Report aggregation.
Configures the source IP address used as a proxy for IGMP Group Specific
Queries.
Configuration Menu
162

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

1:10gbe

Table of Contents