Rip Interface Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Command Reference Manual

The following table describes the RIP Configuration Menu options.
RIP Configuration Menu options
Table 131
Command
if <1-255>
update <1-120>
redist
on
off
cur

RIP Interface configuration

Command: /cfg/l3/rip/if <1-255>
[RIP Interface 1 Menu]
The RIP Menu is used for configuring Routing Information Protocol parameters. This option is turned off by
default.
NOTE:
Do not configure RIP version 1 parameters if your routing equipment uses RIP version 2.
The following table describes the RIP Interface Configuration Menu options.
RIP Interface Configuration Menu options
Table 132
Command
version 1|2|both
supply disable|enable
listen disable|enable
Description
Displays the RIP Interface menu.
Configures the time interval for sending for RIP table updates, in seconds.
The default value is 30 seconds.
Displays the RIP Route Redistribute menu.
Globally turns RIP on.
Globally turns RIP off.
Displays the current RIP configuration.
version - Set RIP version
supply - Enable/disable supplying route updates
listen - Enable/disable listening to route updates
poison - Enable/disable poisoned reverse
split - Enable/disable split horizon
trigg - Enable/disable triggered updates
mcast - Enable/disable multicast updates
default - Set default route action
metric - Set metric
auth - Set authentication type
key - Set authentication key
enable - Enable interface
disable - Disable interface
current - Display current RIP interface configuration
Description
Configures the RIP version used by this interface.
The default value is version 2.
When enabled, the switch supplies routes to other routers. This command is
enabled by default.
When enabled, the switch learns routes from other routers. This command is
enabled by default.
Configuration Menu
153