User Security Model Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Command Reference Manual

Table 85 SNMPv3 Configuration Menu options
Command
taddr <1-16>
tparam <1-16>
notify <1-16>
v1v2 disable|enable
cur

User Security Model configuration

Command: /cfg/sys/ssnmp/snmpv3/usm
[SNMPv3 usmUser 1
You can make use of a defined set of user identities using this Security Model. An SNMP engine must
have the knowledge of applicable attributes of a user.
This menu helps you create a user security model entry for an authorized user. You need to provide a
security name to create the USM entry.
The following table describes the User Security Model Configuration Menu options.
Table 86 User Security Model Configuration Menu options
Command
name <1-32 characters>
auth md5|sha|none
authpw
Description
Configures the destination address and user security levels for outgoing notifications.
This is also called the transport endpoint. The range is 1-16.
Configures SNMP parameters, consisting of message processing model, security
model, security level, and security name information. There may be multiple transport
endpoints associated with a particular set of SNMP parameters, or a particular
transport endpoint may be associated with several sets of SNMP parameters.
Configures a notification index. A notification application typically monitors a system
for particular events or conditions, and generates Notification-Class messages based
on these events or conditions. The range is 1-16.
Enables or disables the access to SNMP version 1 and version 2. This command is
enabled by default.
Displays the current SNMPv3 configuration.
Menu]
name - Set USM user name
auth - Set authentication protocol
authpw - Set authentication password
priv - Set privacy protocol
privpw - Set privacy password
del - Delete usmUser entry
cur - Display current usmUser configuration
Description
Configures a string up to 32 characters long that represents the name of the user.
This is the login name that you need in order to access the switch.
Configures the authentication protocol between HMAC-MD5-96 or HMAC-SHA-96.
The default algorithm is none.
Configures your password for authentication. If you selected an authentication
algorithm using the above command, you need to provide a password; otherwise
you will get an error message during validation.
Configuration Menu
116