Vrrp Virtual Router Priority Tracking Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Command Reference Manual

Table 152 Virtual Router Configuration Menu options
Command
if <1-255>
prio <1-254>
adver <1-255>
preem disable|enable
ena
dis
del
cur

VRRP Virtual Router Priority Tracking configuration

Command: /cfg/l3/vrrp/vr <1-255>/track
[VRRP Virtual Router 1 Priority Tracking Menu]
This menu is used for modifying the priority system used when electing the master router from a pool of
virtual routers. Various tracking criteria can be used to bias the election results. Each time one of the
tracking criteria is met, the priority level for the virtual router is increased by an amount defined through
the VRRP Tracking Menu.
Criteria are tracked dynamically, continuously updating virtual router priority levels when enabled. If the
virtual router preemption option is enabled, this virtual router can assume master routing authority when its
priority level rises above that of the current master.
Description
Selects a switch IP interface. If the IP interface has the same IP address as the
addr option above, this switch is considered the "owner" of the defined virtual
router. An owner has a special priority of 255 (highest) and will always assume
the role of master router, even if it must preempt another virtual router which has
assumed master routing authority. This preemption occurs even if the preem
option below is disabled. The default value is 1.
Defines the election priority bias for this virtual server. This can be any integer
between 1 and 254. The default value is 100.
During the master router election process, the routing device with the highest
virtual router priority number wins. If there is a tie, the device with the highest IP
interface address wins. If this virtual router's IP address (addr) is the same as the
one used by the IP interface, the priority for this virtual router will automatically be
set to 255 (highest).
When priority tracking is used (/cfg/l3/vrrp/track or
/cfg/l3/vrrp/vr #/track), this base priority value can be modified
according to a number of performance and operational criteria.
Defines the time interval between VRRP master advertisements. This can be any
integer between 1 and 255 seconds. The default value is 1.
Enables or disables master preemption. When enabled, if this virtual router is in
backup mode but has a higher priority than the current master, this virtual router
will preempt the lower priority master and assume control. Note that even when
preem is disabled, this virtual router will always preempt any other master if this
switch is the owner (the IP interface address and virtual router addr are the
same). By default, this option is enabled.
Enables this virtual router.
Disables this virtual router.
Deletes this virtual router from the switch configuration.
Displays the current configuration information for this virtual router.
vrs - Enable/disable tracking master virtual routers
ifs - Enable/disable tracking other interfaces
ports - Enable/disable tracking VLAN switch ports
cur - Display current VRRP virtual router configuration
Configuration Menu
169