NETGEAR GS110TP - ProSafe Gigabit Smart Switch Software Administration Manual page 77

Port Speed. Use the menu to select the port's speed and duplex mode. If you select
•
Auto, the duplex mode and speed will be set by the auto-negotiation process. The
port's maximum capability (full duplex and 1000 Mbps) will be advertised. Otherwise,
your selection will determine the port's duplex mode and transmission rate. The
factory default is Auto.
Sleep Mode. Use the menu to select the port's Green Ethernet mode, which can be
•
one of the following:
Enable: Specifies that when the port link is down, the port automatically goes
•
down for a short amount of time and wakes up to check link pulses. When the port
does not have a link partner, the sleep mode reduces power consumption.
Disable: The port provides full power to the port even if there is no link partner.
•
Short Cable Mode. Use the menu to select the port's Green Ethernet mode, which
•
can be one of the following:
Enable: Specifies that cable test is performed when the port link is up at 1 Gbps
•
and if the cable is less than 10m, PHYs are placed in low power mode (nominal
power).
Disable: The port does not participate in Green Ethernet mode.
•
Physical Status. Indicates the physical port's speed and duplex mode
•
Link Status. Indicates whether the Link is up or down.
•
Link Trap. This object determines whether or not to send a trap when link status
•
changes. The factory default is Enable.
Enable: Specifies that the system sends a trap when the link status changes.
•
Disable: Specifies that the system does not send a trap when the link status
•
changes.
Maximum Frame Size. Specify the maximum Ethernet frame size the interface
•
supports or is configured to support. The frame size includes the Ethernet header,
CRC, and payload. (1518–9216). The default maximum frame size is 1518.
MAC Address. Displays the physical address of the specified interface.
•
PortList Bit Offset. Displays the bit offset value which corresponds to the port when
•
the MIB object type PortList is used to manage in SNMP.
ifIndex. The ifIndex of the interface table entry associated with this port. If the
•
interface field is set to All, this field is blank.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
6.
the latest value of the switch.
If you make any changes to the page, click Apply to apply the changes to the system.
7.
10 | Chapter 3: Configuring Switching Information
GS108T and GS110TP Smart Switch Software Administration Manual