Rapid Stp - NETGEAR GS110TP - ProSafe Gigabit Smart Switch Software Administration Manual

Field
Designated Cost
Designated Bridge
Designated Port
Topology Change
Acknowledge
Edge Port
Point-to-point MAC
CST Regional Root
CST Path Cost
Port Forwarding State
Click Refresh to update the information on the screen with the most current data.

Rapid STP

Use the Rapid STP page to view information about Rapid Spanning Tree (RSTP) port status.
To display the Rapid STP page, click Switching > STP > Advanced  RSTP.
34 | Chapter 3: Configuring Switching Information
GS108T and GS110TP Smart Switch Software Administration Manual
Description
Displays cost of the port participating in the STP topology. Ports with a lower
cost are less likely to be blocked if STP detects loops.
Bridge Identifier of the bridge with the Designated Port. It is made up using
the bridge priority and the base MAC address of the bridge.
Port Identifier on the Designated Bridge that offers the lowest cost to the
LAN. It is made up from the port priority and the interface number of the port.
Identifies whether the next BPDU to be transmitted for this port would have
the topology change acknowledgement flag set. It is either True or False.
Indicates whether the port is enabled as an edge port. Possible values are
Enabled or Disabled.
Derived value of the point-to-point status.
Displays the bridge priority and base MAC address of the CST Regional
Root.
Displays the path Cost to the CST tree Regional Root.
Displays the Forwarding State of this port.