Port Vlan Id Configuration - NETGEAR GS110TP - ProSafe Gigabit Smart Switch Software Administration Manual

Use the Group Operations field to select all the ports and configure them. Possible values
5.
are:
Untag All: Select all the ports on which all frames transmitted from this VLAN will be
•
untagged. All the ports will be included in the VLAN.
Tag All: Select the ports on which all frames transmitted for this VLAN will be tagged.
•
All the ports will be included in the VLAN.
Remove All: This selection has the effect of excluding all ports from the selected
•
VLAN.
Click Cancel to cancel the configuration on the screen and reset the data on the screen to
6.
the latest value of the switch.
If you make any changes to this page, click Apply to send the updated configuration to the
7.
switch. Configuration changes take place immediately.

Port VLAN ID Configuration

The Port PVID Configuration screen lets you assign a port VLAN ID (PVID) to an interface.
There are certain requirements for a PVID:
All ports must have a defined PVID.
•
If no other value is specified, the default VLAN PVID is used.
•
If you want to change the port's default PVID, you must first create a VLAN that includes
•
the port as a member.
Use the Port VLAN ID (PVID) Configuration page to configure a virtual LAN on a port.
•
To access the Port PVID Configuration page, click Switching VLAN  Advanced  Port
PVID Configuration.
20 | Chapter 3: Configuring Switching Information
GS108T and GS110TP Smart Switch Software Administration Manual