Note:
❏ To activate Buffer Size settings, you must turn off the printer for more than five seconds then turn it back
on. Or, you can perform a Reset All operation, as explained in "Reset Menu" on page 65.
❏ Resetting the printer erases all print jobs. Make sure the Ready light is not flashing when you reset the
printer.
USB Menu
Item
*1
USB I/F
*1 *2
USB Speed
*2 *3
Get IP Address
*2 *3 *4 *5
IP
*2 *3
SM
*2 *3
GW
*2 *3
NetWare
*2 *3
AppleTalk
*2 *3
MS Network
*2 *3
Bonjour
*2 *3
USB Ext I/F Init
*1 *2
Buffer Size
*1
After this item is changed, the setting value takes effect after a warm boot or after the power is turned on again.
While it is reflected in the Status Sheet and EJL read-back, the actual change takes effect after a warm boot or
after the power is turned on again.
*2
Available only when USB I/F is set to On.
*3
Available only when a USB external device with D4 support is connected. The contents of the settings depend on
the USB external device settings.
*4
If the Get IPAddress setting is set to Auto, this setting cannot be changed.
*5
When the Get IPAddress setting is changed from Panel or PING to Auto, the panel setting values are saved. Then
Auto is changed back to Panel or PING, the saved setting values are displayed. The value is set to 192.168.192.168 if
the settings are not made from the panel.
Settings (default in bold)
On, Off
HS, FS
Panel, Auto, PING
0.0.0.0 to 255.255.255.255
0.0.0.0 to 255.255.255.255
0.0.0.0 to 255.255.255.255
On, Off
On, Off
On, Off
On, Off
-
Normal, Maximum, Minimum
AcuLaser M4000 Series
Using the Control Panel
User's Guide
67