Epson AcuLaser M4000N User Manual page 83

AcuLaser M4000 Series User's Guide
Feed Roller C2 Needed Soon, Feed Roller C3 Needed Soon
This message indicates that the feed roller C2 or C3 is near the end of its service life. You can
continue to print until the Replace Feed Roller C2 or Replace Feed Roller C3 message
appears. Prepare a new feed roller.
To clear this warning message and continue printing, select Clear All Warnings from the control
panel's Reset Menu. For instruction about accessing the control panel menus, see "How to access
the control panel menus" on page 53.
Form Data Canceled
Unable to store form overlay data on the printer's optional Hard Disk Drive. Either the drive is full,
or the maximum number of form overlay files has been reached. Delete any form overlay files you
no longer need, then try storing the new overlay again.
To clear this error, select Clear Warning from the control panel's Reset Menu. For instruction
about accessing the control panel menus, see "How to access the control panel menus" on page 53.
Form Feed
The printer is ejecting paper due to a user request. This message appears when pressing the
Start/Stop button once to make the printer offline, then holding down the Start/Stop button for
more than 2 seconds in order not to receive form feed command.
Formatting HDD
The Hard Disk Drive is being formatted.
Fuser Needed Soon
This message indicates that the fuser unit is near the end of its service life. You can continue to print
until the Replace Fuser message appears. Prepare a new fuser unit.
To clear this warning message and continue printing, select Clear All Warnings from the control
panel's Reset Menu. For instruction about accessing the control panel menus, see "How to access
the control panel menus" on page 53.
Hard Disk full
The optional Hard Disk Drive is full and you cannot save any data. Delete the unnecessary data
from the Hard Disk Drive. To clear this error, select Clear Warning from the control panel's
Reset Menu. For instruction about accessing the control panel menus, see "How to access the
control panel menus" on page 53.
Using the Control Panel 83