Epson AcuLaser M4000N User Manual page 14

❏ Be careful not to touch the fuser, which is marked CAUTION HOT SURFACE or CAUTION
HIGH TEMPERATURE, or the surrounding areas. If the printer has been in use, the fuser and
the surrounding areas may be very hot. If you must touch one of these areas, wait 30 minutes
to allow the heat to subside before doing so.
a
a. CAUTION HOT SURFACE
b. CAUTION HIGH TEMPERATURE
❏ Do not insert your hand deep into the fuser unit as some components are sharp and may cause
injury.
❏ Avoid touching the components inside the printer unless instructed to do so in this guide.
❏ Never force the printer's components into place. Although the printer is designed to be sturdy,
rough handling can damage it.
❏ When handling an imaging cartridge, always place it on a clean, smooth surface.
❏ Do not attempt to modify an imaging cartridge or take it apart. It cannot be refilled.
❏ Do not touch the toner. Keep the toner away from your eyes.
❏ Do not dispose of used imaging cartridge in fire, as they can explode and cause injury. Dispose
of them according to local regulations.
❏ If toner is spilled, use a broom and dustpan or a damp cloth with soap and water to clean it up.
Because the fine particles can cause a fire or explosion if they come into contact with a spark, do
not use a vacuum cleaner.
❏ Wait at least one hour before using an imaging cartridge after moving it from a cool to a warm
environment to prevent damage from condensation.
AcuLaser M4000 Series
b
User's Guide
Safety Instructions 14