Epson AcuLaser M4000N User Manual page 87

AcuLaser M4000 Series User's Guide
Paper Set tttt sssss
The paper loaded in the specified paper source (tttt) does not match the required paper size
(sssss). Replace the loaded paper with the correct size paper and press the Start/Stop button to
resume printing, or press the + Cancel Job button to cancel the print job.
If you press the Start/Stop button without replacing the paper, the printer will print on the loaded
paper even though it does not match the required size.
Password Changed
The password has been changed successfully.
Print Overrun
The required time to process the print data exceeded the print engine speed because the current
page is too complex. Press the Start/Stop button to resume printing, or press the + Cancel Job
button to cancel the print job. If this message appears again, select On as the Page Protect setting
in the control panel's Setup Menu or select Avoid Page Error on the printer driver.
If you continue to receive this message when printing a particular page, try simplifying the page
by limiting the number of graphics or reducing the number and size of fonts.
To avoid this error, it is recommended that you set the Page Protect setting to On and add more
memory to the printer. See "Setup Menu" on page 61 and "Memory Module" on page 106 for
details.
PS3 Hard Disk full
The memory allocated for writing PostScript 3 commands on the optional Hard Disk Drive is full.
To clear this error, select Clear Warning from the control panel's Reset Menu. For instruction
about accessing the control panel menus, see "How to access the control panel menus" on page 53.
RAM CHECK
The printer is checking the RAM.
Ready
The printer is ready to receive data and print.
Replace Feed Roller C2, Replace Feed Roller C3
The feed roller C2 or C3 has reached the end of its service life and needs to be replaced. If this error
occurs, consult your dealer.
Using the Control Panel 87